Introducing The StrobeStopper! 

KraftySolutions’ Patent Pending StrobeStopper increases towing safety, to help prevent Rear-End Collisions! It is designed for LED Trailer lights that anyone hauling a trailer can install effortlessly. You simply plug one end of the harness directly into the back of the tow vehicle (typically a 4-Flat or 7-Way), and the other end into the trailer. Once attached correctly, the device will make your trailer Brake lights blink rapidly, then stay solid after catching the attention of the drivers behind you MUCH faster!

thin

“Rear-end crashes are the most frequently occurring type of collision, accounting for approximately 29 percent of all crashes and resulting in a substantial number of injuries and fatalities each year.”-The National Highway Traffic Safety Administration (NHTSA) 2007.

View the entire article here: Click Here

StrobeStopper is designed to help decrease the chances of you becoming part of these statistics! Whether it be your camper, horse trailer, or even just the flat trailer with that 1969 Corvette on it, a rear end

collision is not just inconvenient but can cause substantial injury to you or

your beloved cargo.

The NHTSA has also done studies that show almost 70% of people looked up to a flashing light, compared to a light that was steady burning that showed 10%. They concluded with “This research demonstrated that flashing all lights simultaneously or alternately flashing is a promising signal for use in enhanced brake light applications, even at levels of brightness within the current regulated limits.”- The National Highway Traffic Safety Administration (NHTSA) 2010. View the entire article here: Click Here

0:00
0:00

We have designed the StrobeStopper to be truly Plug and Play! Anyone that can hookup a trailer, can install the StrobeStopper in a matter of seconds to increase your visibility when stopping, and give you a little extra piece of mind. StrobeStopper comes in two different variations of the harness: 

StrobeStopper also increases your visibility when turning!

0:00
0:00

4-Flat


Our 4-Flat version is common on smaller trailers without brakes, such as small boats, utility trailers, or jet ski trailers. The 4-Flat measures in at 24 inches long, so it can also serve as an extension for that trailer wiring that just barely makes it to the truck. It is made with the same 18G wiring as most trailers currently use.

7-Way


The 7-way is used for Heavy Duty Trailers such as Horse Trailers, pull behind Campers, large utility trailers, and More. The 7-way is close to 50 inches long, good for extending to 5th wheel hitches too! The 7 way uses the RV Standard wiring schematic, and is wired using 14G, 12G and 10G wiring.

KraftySolutions is committed to quality. All of our products are hand inspected before

shipping. If you have any issues with our products, be sure to contact us directly at: Support@KraftySolutions.com


Please note: StrobeStopper’s Patent Pending computer module is designed to work with LED trailer lights (not with the older style incandescent lights as the filament inside cannot heat up as fast as LED lights do). Remember to check local laws and regulations in your area to be sure you are staying compliant.


Be sure to checkout some of the other products we offer! If you do not currently have LED lights installed on your Trailer, they are typically very easy to change out, and can dramatically increase brightness on any trailer!


Also remember to checkout our demonstration videos on YouTube, and to subscribe for discounts, and NEW Products!


Thank YOU for visiting!

Enter your info below. If you have any questions, concerns, or just want to say HI. We'll get back to you within 24 hours or email us directly at: Support@KraftySolutions.com

Get 15% off your first purchase on Amazon, using code "15PromoOff" while it lasts!"!

X